How to make a Cygnet Plane

Step one you need to cut out number 1 and 2 which are the wings. After that you have to put the small part on to the big part and then glue them together.
Fold wings gently as shown on the left and turn up the wing tips. Then add a strip of tape at the top and bottom of the wing to help it from bending in the air.
Now perpare the motor stick. mark with a soft pencil.You will use this to position the wing support. Also wrap tape around the motor stick before pushing in the pin, which is measured 250mm from the end of the motor stick.
First you have to cut numbers 3, 4 and 5. Glue 3 and 4 around the motor stick and add number 5 to give it extra support. After that we bent the end of number 3and 4 and stuck the wings on.
The last bit of the making the cygnet was flying it. What we had to do was let go of the plane, with the propellor spinning.